Removing center console
2 posters
Removing center console
Is there any where on this board about removing center console ? I have a general idea but was hoping that someone had pics and instructions . Thanks
lagunaman- G3GM Member
- Street Cred : 0
Re: Removing center console
It's pretty straight-forward.
First thing you'll want to do is remove the shifter knob. Start by prying off the cap. There are two indented slots across from each other under the lip of the cap for use in applying a flat-bladed screwdriver to pry upwards. That cap is held in place by a metal "u" shaped clip that is pressed into the bottom of the cap and has small "nubs" that grab the shifter shaft. Sometimes the cap pops right off. Other times, you have to work at it.
Next, you'll need to remove the c-clip at the inside bottom of the knob. Once that's done, the knob will lift straight up and off the shaft (in a perfect world, that is). More often that not, the knob is stuck on the shaft and will need some persuasion.
All that's left is to start removing visible screws and bolts. Don't forget the two screws at the forward end of the upper console pad. One other tip...it's easier to remove the storage box to access the bolts underneath if you open the lid fully. It gives more clearance for the lid spring to slide out of the lower section of console. Ask if you have any questions.
First thing you'll want to do is remove the shifter knob. Start by prying off the cap. There are two indented slots across from each other under the lip of the cap for use in applying a flat-bladed screwdriver to pry upwards. That cap is held in place by a metal "u" shaped clip that is pressed into the bottom of the cap and has small "nubs" that grab the shifter shaft. Sometimes the cap pops right off. Other times, you have to work at it.
Next, you'll need to remove the c-clip at the inside bottom of the knob. Once that's done, the knob will lift straight up and off the shaft (in a perfect world, that is). More often that not, the knob is stuck on the shaft and will need some persuasion.
All that's left is to start removing visible screws and bolts. Don't forget the two screws at the forward end of the upper console pad. One other tip...it's easier to remove the storage box to access the bolts underneath if you open the lid fully. It gives more clearance for the lid spring to slide out of the lower section of console. Ask if you have any questions.
Mcarlo77- Donating Member
- Street Cred : 77
TW Monte likes this post
Permissions in this forum:
You cannot reply to topics in this forum
|
|
Today at 12:54 pm by 76 Malibu
» Anyone good at photoshop?
Today at 12:50 pm by 76 Malibu
» Rusty's progress Done stuff again LOL
Today at 8:37 am by zucchi
» '77 Monte Carlo Landau - Parting out - 61k miles on car
Fri May 10, 2024 5:02 pm by Matchstx
» 1973 4 door laguna frame same as 1973 2 door chevelle
Fri May 10, 2024 4:56 pm by Matchstx
» Dash assembly for 73-77 Malibu/Monte/El Camino,etc.
Fri May 10, 2024 2:48 pm by Limey SE
» Window louvers
Fri May 10, 2024 12:47 pm by JCervantes10
» 1973 Chevelle SS 1 Family
Wed May 08, 2024 8:11 am by Mitchell Murphy
» 1973 Chevelle SS, 350, 4spd. build
Wed May 08, 2024 8:09 am by Mitchell Murphy
» Who works on 73-77 "soft" steering wheels?
Tue May 07, 2024 12:46 pm by relic7680