Need help identifing a part
2 posters
G3GM :: G3 Tech :: Engine & Driveline
Page 1 of 1
Need help identifing a part
I think it's some sort of cold start valve?
" />
" />
Shaunaconda- G3GM Member
- Street Cred : 0
Re: Need help identifing a part
Are you asking about the silver cylinder with the yellow barbed fitting under the PVC pipe, or the UFO shaped, silver valve, that's lower in the picture?
Pontichev327- G3GM Enthusiast
- Street Cred : 7
Re: Need help identifing a part
I'm asking about the silver cylinder. A piece of the yellow fitting cracked off. If you look close you can see it stuck in the vacuum hose just under the wires. This is on my '75 Elky with the 454.
Shaunaconda- G3GM Member
- Street Cred : 0
G3GM :: G3 Tech :: Engine & Driveline
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|
Sat May 18, 2024 1:56 pm by REVINKEVIN / Mr. 600+HP
» Pate Swap Meet - Texas Motor Speedway - G3 Parts Goldmine
Sat May 18, 2024 12:20 pm by g3chevy / Mr Pontiac
» '73 Laguna coupe - factory 454- SoCal $2500
Fri May 17, 2024 4:38 pm by Mcarlo77
» Dash Solutions
Fri May 17, 2024 3:22 pm by 76 Malibu
» Rusty's progress Done stuff again LOL
Thu May 16, 2024 12:56 pm by Limey SE
» 1973 4 door laguna frame same as 1973 2 door chevelle
Tue May 14, 2024 4:39 pm by chevelleman
» Anyone good at photoshop?
Mon May 13, 2024 12:50 pm by 76 Malibu
» '77 Monte Carlo Landau - Parting out - 61k miles on car
Fri May 10, 2024 5:02 pm by Matchstx
» Dash assembly for 73-77 Malibu/Monte/El Camino,etc.
Fri May 10, 2024 2:48 pm by Limey SE
» Window louvers
Fri May 10, 2024 12:47 pm by JCervantes10