Cam Bearing Tool
3 posters
G3GM :: G3 Tech :: Engine & Driveline
Page 1 of 1
Cam Bearing Tool
I just bought a cam bearing install/remove tool, off ebay. Here is the link http://www.ebay.com/itm/380465586090?ssPageName=STRK:MEWNX:IT&_trksid=p3984.m1497.l2649
I have to say its pretty well made. I just removed my cam bearings in just a couple of minutes. I know it does small block chevys and I believe V6's as well. No mention of doing other brand engines. No instructions were included with the tool but its real simple to figure out. There's also youtube videos that show you have to do it.
So if anyone is interested in doing their own bearings, this tool is worth it. Especially for only $34 delivered.
Ant7377, your more than welcome to borrow it anytime.
I have to say its pretty well made. I just removed my cam bearings in just a couple of minutes. I know it does small block chevys and I believe V6's as well. No mention of doing other brand engines. No instructions were included with the tool but its real simple to figure out. There's also youtube videos that show you have to do it.
So if anyone is interested in doing their own bearings, this tool is worth it. Especially for only $34 delivered.
Ant7377, your more than welcome to borrow it anytime.
Joe73- Donating Member
- Street Cred : 83
Re: Cam Bearing Tool
Hey Joe ! That was a decent price.
Over the years I made my own parts for mine, to do Pontiacs, Cadillacs, Hemi Chryslers etc, to fit the original tool.
Over the years I made my own parts for mine, to do Pontiacs, Cadillacs, Hemi Chryslers etc, to fit the original tool.
pila- Donating Member
- Street Cred : 43
Re: Cam Bearing Tool
Cool. Good tool to have. I'm looking for a bore gauge if anyone is selling one cheap. I'd even take a harbor freight one but they dont make them anymore.
Joe73- Donating Member
- Street Cred : 83
G3GM :: G3 Tech :: Engine & Driveline
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|
Yesterday at 1:56 pm by REVINKEVIN / Mr. 600+HP
» Pate Swap Meet - Texas Motor Speedway - G3 Parts Goldmine
Yesterday at 12:20 pm by g3chevy / Mr Pontiac
» '73 Laguna coupe - factory 454- SoCal $2500
Fri May 17, 2024 4:38 pm by Mcarlo77
» Dash Solutions
Fri May 17, 2024 3:22 pm by 76 Malibu
» Rusty's progress Done stuff again LOL
Thu May 16, 2024 12:56 pm by Limey SE
» 1973 4 door laguna frame same as 1973 2 door chevelle
Tue May 14, 2024 4:39 pm by chevelleman
» Anyone good at photoshop?
Mon May 13, 2024 12:50 pm by 76 Malibu
» '77 Monte Carlo Landau - Parting out - 61k miles on car
Fri May 10, 2024 5:02 pm by Matchstx
» Dash assembly for 73-77 Malibu/Monte/El Camino,etc.
Fri May 10, 2024 2:48 pm by Limey SE
» Window louvers
Fri May 10, 2024 12:47 pm by JCervantes10