Shift indicator screw!
+2
JiMi_DRiX
BlackChevelleSS
6 posters
G3GM :: G3 :: General Discussion
Page 1 of 1
Shift indicator screw!
Hey everyone, I seem to have misplaced or lost a very tiny little screw. Its the one that clamps the bracket to the steering column that pulls the little wire on the gauges for PRND21. Does anyone have a picture of one or know what size it is? I need a replacement. I'm going to check a couple clusters I have in storage, but I'm doubtful they are there. Thanks!
JiMi_DRiX- G3GM Enthusiast
- Street Cred : 3
Re: Shift indicator screw!
I can give the one I took off for the Column switch if I can locate it fast enough for you
___________________________________________
1977 Chevelle SE x2
One Mild original
one Wild NON original
Anthony
Limey SE- Management
- Street Cred : 97
Re: Shift indicator screw!
weird but ive never installed a screw in any of mine.
___________________________________________
www.cardomain.com/id/3115ultima
BlackChevelleSS- Management
- Street Cred : 20
Re: Shift indicator screw!
Thanks Limey. I'm going to take a look at my extra sets of gauges and see if there is one on there. I know I probably set it aside somewhere, in a little plastic bag, so I wouldnt lose it, but guess what... haha.
BlackChevelleSS, really? Mine wont stay without it. It'll move, but not correctly. Drive is R at the moment, lol
BlackChevelleSS, really? Mine wont stay without it. It'll move, but not correctly. Drive is R at the moment, lol
JiMi_DRiX- G3GM Enthusiast
- Street Cred : 3
Re: Shift indicator screw!
Jimi did you get any info or find it? Might have mine screwed to the other piece...Let me know & I'll post a pic tomorrow probably.
77mali- Donating Member
- Street Cred : 62
Re: Shift indicator screw!
I am going out right now to look for you ..........
___________________________________________
1977 Chevelle SE x2
One Mild original
one Wild NON original
Anthony
Limey SE- Management
- Street Cred : 97
Re: Shift indicator screw!
JiMi_DRiX wrote:Thanks Limey. I'm going to take a look at my extra sets of gauges and see if there is one on there.
Shoot me your Addy Jimi I have it sitting here on my desk!!! Unless you want me to take to Hardware store to get right size and then you buy there ??
___________________________________________
1977 Chevelle SE x2
One Mild original
one Wild NON original
Anthony
Limey SE- Management
- Street Cred : 97
Re: Shift indicator screw!
LOL...I went to take a pic and mine is missing too! Tiny little sucker.
77mali- Donating Member
- Street Cred : 62
Re: Shift indicator screw!
yea they are big time ( pardon the pun ) I will go to hardware store tomm and get size then you guys can just buy them there at local true value / ace hardware
___________________________________________
1977 Chevelle SE x2
One Mild original
one Wild NON original
Anthony
Limey SE- Management
- Street Cred : 97
Re: Shift indicator screw!
I seem to remember that it's a #6 X 1/4 flat head sheet metal screw...
pila- Donating Member
- Street Cred : 43
Re: Shift indicator screw!
Let me know if you still need one. Just installed mega shifter. Wont be needing mine.
Tom77- Donating Member
- Street Cred : 9
G3GM :: G3 :: General Discussion
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
Sat May 18, 2024 1:56 pm by REVINKEVIN / Mr. 600+HP
» Pate Swap Meet - Texas Motor Speedway - G3 Parts Goldmine
Sat May 18, 2024 12:20 pm by g3chevy / Mr Pontiac
» '73 Laguna coupe - factory 454- SoCal $2500
Fri May 17, 2024 4:38 pm by Mcarlo77
» Dash Solutions
Fri May 17, 2024 3:22 pm by 76 Malibu
» Rusty's progress Done stuff again LOL
Thu May 16, 2024 12:56 pm by Limey SE
» 1973 4 door laguna frame same as 1973 2 door chevelle
Tue May 14, 2024 4:39 pm by chevelleman
» Anyone good at photoshop?
Mon May 13, 2024 12:50 pm by 76 Malibu
» '77 Monte Carlo Landau - Parting out - 61k miles on car
Fri May 10, 2024 5:02 pm by Matchstx
» Dash assembly for 73-77 Malibu/Monte/El Camino,etc.
Fri May 10, 2024 2:48 pm by Limey SE
» Window louvers
Fri May 10, 2024 12:47 pm by JCervantes10