valve covers (pay shipping)
2 posters
G3GM :: Classifieds :: Freebie Section
Page 1 of 1
valve covers (pay shipping)
if someone want to pay for shipping i can send you these alum. valve covers for small block chevys
i got them for my adjustments...they COULD be cleaned up but they are just spares for when you adjust roller rockers, you can cut the tops out of them so oil wont spill over the motor and you dont remove/install them 100 times for adjustment. i cleaned one to show they are good for that. just want em gone so if someone wants em PM your zip code ill et a shipping price and they are yours...
[img][/img]
[img][/img]
i got them for my adjustments...they COULD be cleaned up but they are just spares for when you adjust roller rockers, you can cut the tops out of them so oil wont spill over the motor and you dont remove/install them 100 times for adjustment. i cleaned one to show they are good for that. just want em gone so if someone wants em PM your zip code ill et a shipping price and they are yours...
[img][/img]
[img][/img]
coreys73chevelle- G3GM Senior Member
- Street Cred : 8
Re: valve covers (pay shipping)
afraid to tell you thems not alum them stamped steel (alum dont rust like that)
dragons_lair59- Donating Member
- Street Cred : 11
Re: valve covers (pay shipping)
whatever they are theyre free. rust isnt bad its gt a lot of dirt in them and the tops were going to gettin cut anyway, pretty much just a tool instead of a part
coreys73chevelle- G3GM Senior Member
- Street Cred : 8
Similar topics
» BBC Valve Covers
» WTB SBC Comp Cams Cast Valve Covers like in pic.
» Edelbrock Performer SBC manifold : Chevrolet cast aluminum finned valve covers
» WTB SBC Comp Cams Cast Valve Covers like in pic.
» Edelbrock Performer SBC manifold : Chevrolet cast aluminum finned valve covers
G3GM :: Classifieds :: Freebie Section
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|
Yesterday at 1:56 pm by REVINKEVIN / Mr. 600+HP
» Pate Swap Meet - Texas Motor Speedway - G3 Parts Goldmine
Yesterday at 12:20 pm by g3chevy / Mr Pontiac
» '73 Laguna coupe - factory 454- SoCal $2500
Fri May 17, 2024 4:38 pm by Mcarlo77
» Dash Solutions
Fri May 17, 2024 3:22 pm by 76 Malibu
» Rusty's progress Done stuff again LOL
Thu May 16, 2024 12:56 pm by Limey SE
» 1973 4 door laguna frame same as 1973 2 door chevelle
Tue May 14, 2024 4:39 pm by chevelleman
» Anyone good at photoshop?
Mon May 13, 2024 12:50 pm by 76 Malibu
» '77 Monte Carlo Landau - Parting out - 61k miles on car
Fri May 10, 2024 5:02 pm by Matchstx
» Dash assembly for 73-77 Malibu/Monte/El Camino,etc.
Fri May 10, 2024 2:48 pm by Limey SE
» Window louvers
Fri May 10, 2024 12:47 pm by JCervantes10