G3GM
Would you like to react to this message? Create an account in a few clicks or log in to continue.

G3GM 1973 to 1977 A-bodys. Chevelles, Monte Carlos, El Caminos, Laguna, 442, Cutlass, Malibu, GTO, LeMans, Century, Regal, Grand Am, Grand Prix, Sprint, Gran Sport, Can Am, Hurst-olds, and other 73-77 A-bodies


anyone used any of these?

+6
Limey SE
JasonZ
j
JB2wheeler
McCauley5983
jonny o
10 posters

G3GM :: G3 Tech :: Engine & Driveline

Go down

anyone used any of these? Empty anyone used any of these?

Post by coreys73chevelle Thu Sep 18, 2008 6:40 pm

NOS- powershot plate system- 125hp non adjustable-

and-

Spohn.net- TopGun driveshaft or Extreme duty driveshaft-
coreys73chevelle
coreys73chevelle
G3GM Senior Member
G3GM Senior Member

Street Cred : 8

Back to top Go down

anyone used any of these? Empty Re: anyone used any of these?

Post by jonny o Thu Sep 18, 2008 9:34 pm

Short answer: no

Long Answer: In my opinion, nitrous should be built for and used, or it should be left alone. If you are building a motor for nitrous (Or that is ready for nitrous at a later date) then you should go for an adjustable system.

If you aren't building a motor for nitrous, then this system might be a good rarely used addition.

Remember though, you need to adjust fuel and timing to use it safely and effectively. That's where a lot of people go wrong... tuning a motor for natural aspiration then adding nitrous and thinking they can get away with spraying it "only once in a while." Ever seen a piston melt?

My vote goes for using the money to build a motor that will build more power without nitrous... For about a hundred extra bucks, you can go for a bitchin' damper that will take POUNDS off of your rotating assembly, or get a set of alum roller rockers.

jonny o
G3GM Member
G3GM Member

Street Cred : 2

Back to top Go down

anyone used any of these? Empty Re: anyone used any of these?

Post by BlackChevelleSS Fri Sep 19, 2008 2:34 am

man nitrous is awesome as long as you dont get crazy. Definatly get an adjustable kit. Like the NX mainline system or a more complete kit. NX stands behind their products better than holley (NOS), NX has a lifetime warrenty on their solenoids, and their jets are rated for rear wheel horse instead of crank hp.

___________________________________________
www.cardomain.com/id/3115ultima

anyone used any of these? SIG2
BlackChevelleSS
BlackChevelleSS
Management
Management

Street Cred : 20

Back to top Go down

anyone used any of these? Empty Re: anyone used any of these?

Post by coreys73chevelle Fri Sep 19, 2008 2:51 pm

ok ill get an adjustable then
coreys73chevelle
coreys73chevelle
G3GM Senior Member
G3GM Senior Member

Street Cred : 8

Back to top Go down

anyone used any of these? Empty Re: anyone used any of these?

Post by McCauley5983 Sun Mar 01, 2009 6:47 am

the hell with nitrous. aint need for no cheater spray!
McCauley5983
McCauley5983
G3GM Enthusiast
G3GM Enthusiast

Street Cred : 14

Back to top Go down

anyone used any of these? Empty Re: anyone used any of these?

Post by Hydro King Sun Mar 01, 2009 2:07 pm

I like cheater spray! king
Hydro King
Hydro King
G3GM Enthusiast
G3GM Enthusiast

Street Cred : 4

Back to top Go down

anyone used any of these? Empty Re: anyone used any of these?

Post by JB2wheeler Sun Mar 01, 2009 3:28 pm

You wont catch me using it. I built my engine for maxium power with the main objective being dependability for every day use, if I so desire. JB
JB2wheeler
JB2wheeler
G3GM Fanatic
G3GM Fanatic

Street Cred : 28

Back to top Go down

anyone used any of these? Empty powershot kit

Post by j Sun Mar 01, 2009 10:28 pm

the powershot kit is a good entry level 125hp kit. any bigger and you will need hypereutectic/ or forged pistons, and better rod bolts. you will need to back the timing off (2 degrees for every 50hp). just make sure your fuel pump will maintain 6-7.5 psi throughout the run. whatever you do, dont run the engine lean (fuel pressure)...this is what hurts the pistons (detonation). this kit will work fine on a stock, or mildly built engine, as long as you follow these guidelines !!! also make sure the bottle is at approx. 900psi (on cold nights the bottle will need to be warmed). i have used nitrous on the street / track for 15 years, and have never hurt an engine because of it. I even use it on my alcohol carbed PINTO, a bracket race car ( only for finish line racing, if it is close).
j
j
G3GM Member
G3GM Member

Street Cred : 0

Back to top Go down

anyone used any of these? Empty Re: anyone used any of these?

Post by JasonZ Mon Mar 02, 2009 1:06 am

Hypereutectic would shatter if leaned out. Need forged internals before you play with the giggle juice.

Besides bottles are for baby's. bounce
JasonZ
JasonZ
G3GM Member
G3GM Member

Street Cred : 0

Back to top Go down

anyone used any of these? Empty Re: anyone used any of these?

Post by Limey SE Mon Mar 02, 2009 2:22 pm

HERE YOU GO A MORE ACCURATE DESCRIPTION BUT EVERYONE'S TASTE'S DIFFER

anyone used any of these? Blown10
anyone used any of these? Nuts10
anyone used any of these? Real10


Last edited by THE MALIGOON on Tue Mar 03, 2009 12:58 am; edited 1 time in total

___________________________________________
1977 Chevelle SE x2
One Mild original
one Wild NON original
Anthony
Limey SE
Limey SE
Management
Management

Street Cred : 97

Back to top Go down

anyone used any of these? Empty Re: anyone used any of these?

Post by Hydro King Mon Mar 02, 2009 10:53 pm

Oh snap!
Hydro King
Hydro King
G3GM Enthusiast
G3GM Enthusiast

Street Cred : 4

Back to top Go down

anyone used any of these? Empty Re: anyone used any of these?

Post by BlackChevelleSS Mon Mar 02, 2009 11:49 pm

I like Nitrous, but yea hypereutectic pistons will shatter if detonation occurs, you have to MAKE sure your car is tuned properly N/A and have enough fuel and timing retard to run the nitrous. But I dont think you are running hypers
Detonation has a certian frequency that causes the hypers to shatter, its weird.

___________________________________________
www.cardomain.com/id/3115ultima

anyone used any of these? SIG2
BlackChevelleSS
BlackChevelleSS
Management
Management

Street Cred : 20

Back to top Go down

anyone used any of these? Empty Re: anyone used any of these?

Post by hotrodredneck Tue Mar 03, 2009 9:44 pm

build it big, build it strong, then put it on tha jug just for giggles and git sum! Very Happy
hotrodredneck
hotrodredneck
G3GM Member
G3GM Member

Street Cred : 0

Back to top Go down

anyone used any of these? Empty Re: anyone used any of these?

Post by coreys73chevelle Wed Mar 04, 2009 8:03 pm

yea, ill see how it runs how i have it. then if the motor blows im getting a LSX454
coreys73chevelle
coreys73chevelle
G3GM Senior Member
G3GM Senior Member

Street Cred : 8

Back to top Go down

anyone used any of these? Empty Re: anyone used any of these?

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

G3GM :: G3 Tech :: Engine & Driveline

 
Permissions in this forum:
You cannot reply to topics in this forum