What u-joints are you using
3 posters
G3GM :: G3 :: General Discussion
Page 1 of 1
What u-joints are you using
I bought some Moog replacement U-joints but they don’t fit. Since I had to melt out the plastic from the stock ones I had to buy new ones because the old ones were shot. But now the new ones have the two inner snap rings to go in but if I get one side in then the other side is sticking out.
These are what I bought but don’t seem to fit. https://www.moog-suspension-parts.com/moog-ujoint-packagedeal842
I think I need these https://www.ecklerschevelle.com/chevelle-and-malibu-drive-shaft-universal-joint-with-oututside-lock-up-rings-front-or-rear-1973-1983.html
These are what I bought but don’t seem to fit. https://www.moog-suspension-parts.com/moog-ujoint-packagedeal842
I think I need these https://www.ecklerschevelle.com/chevelle-and-malibu-drive-shaft-universal-joint-with-oututside-lock-up-rings-front-or-rear-1973-1983.html
JF74chevelle- G3GM Member
- Street Cred : 0
Re: What u-joints are you using
Caps sticking out too far usually indicates that some of the needles came loose and are in the ends of the caps. Did you remove the caps and make sure the needles are where they are supposed to be?
bigredlaguna- G3GM Senior Member
- Street Cred : 53
Re: What u-joints are you using
bigredlaguna wrote:Caps sticking out too far usually indicates that some of the needles came loose and are in the ends of the caps. Did you remove the caps and make sure the needles are where they are supposed to be?
That’s a possibility, I’ll check when I get home from work tonight. Thank you
JF74chevelle- G3GM Member
- Street Cred : 0
Re: What u-joints are you using
I use the spicer joints. Not sure who makes moog joints but a lot of them are just reboxed.
bracketchev1221- G3GM Enthusiast
- Street Cred : 15
Similar topics
» putting ball joints in
» Upper ball joints
» Is this safe? trying to remove ball joints with no engine in car
» Upper ball joints
» Is this safe? trying to remove ball joints with no engine in car
G3GM :: G3 :: General Discussion
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|
Yesterday at 1:56 pm by REVINKEVIN / Mr. 600+HP
» Pate Swap Meet - Texas Motor Speedway - G3 Parts Goldmine
Yesterday at 12:20 pm by g3chevy / Mr Pontiac
» '73 Laguna coupe - factory 454- SoCal $2500
Fri May 17, 2024 4:38 pm by Mcarlo77
» Dash Solutions
Fri May 17, 2024 3:22 pm by 76 Malibu
» Rusty's progress Done stuff again LOL
Thu May 16, 2024 12:56 pm by Limey SE
» 1973 4 door laguna frame same as 1973 2 door chevelle
Tue May 14, 2024 4:39 pm by chevelleman
» Anyone good at photoshop?
Mon May 13, 2024 12:50 pm by 76 Malibu
» '77 Monte Carlo Landau - Parting out - 61k miles on car
Fri May 10, 2024 5:02 pm by Matchstx
» Dash assembly for 73-77 Malibu/Monte/El Camino,etc.
Fri May 10, 2024 2:48 pm by Limey SE
» Window louvers
Fri May 10, 2024 12:47 pm by JCervantes10