Year one 350
2 posters
G3GM :: G3 :: General Discussion
Page 1 of 1
Year one 350
https://www.yearone.com/Product/1964-72-chevelle-monte-carlo-el-camino/at350pc1 anyone ran this motor or know anybody that did. I'm really considering this right now. Thanks guys
JF74chevelle- G3GM Member
- Street Cred : 0
Re: Year one 350
I don't think its a bad deal. Its a remanufactured engine with a set of aluminum heads on it. Its no different than any other reman crate engine. ATK and Blueprint are similar.
bracketchev1221- G3GM Enthusiast
- Street Cred : 15
Re: Year one 350
I'm either going to do this or get the ATK sp04 short block then build the top end.
JF74chevelle- G3GM Member
- Street Cred : 0
Re: Year one 350
I would bet the Year One engine is just that with Edelbrock heads on it.
bracketchev1221- G3GM Enthusiast
- Street Cred : 15
G3GM :: G3 :: General Discussion
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|
Sat May 18, 2024 1:56 pm by REVINKEVIN / Mr. 600+HP
» Pate Swap Meet - Texas Motor Speedway - G3 Parts Goldmine
Sat May 18, 2024 12:20 pm by g3chevy / Mr Pontiac
» '73 Laguna coupe - factory 454- SoCal $2500
Fri May 17, 2024 4:38 pm by Mcarlo77
» Dash Solutions
Fri May 17, 2024 3:22 pm by 76 Malibu
» Rusty's progress Done stuff again LOL
Thu May 16, 2024 12:56 pm by Limey SE
» 1973 4 door laguna frame same as 1973 2 door chevelle
Tue May 14, 2024 4:39 pm by chevelleman
» Anyone good at photoshop?
Mon May 13, 2024 12:50 pm by 76 Malibu
» '77 Monte Carlo Landau - Parting out - 61k miles on car
Fri May 10, 2024 5:02 pm by Matchstx
» Dash assembly for 73-77 Malibu/Monte/El Camino,etc.
Fri May 10, 2024 2:48 pm by Limey SE
» Window louvers
Fri May 10, 2024 12:47 pm by JCervantes10