Bell housing help!!!!!
2 posters
G3GM :: G3 :: General Discussion
Page 1 of 1
Bell housing help!!!!!
Currently swapping in my muncie and i bought the wrong bell housing. I have a 10.5" clutch and flywheel 168 tooth. Will a 11" bellhousing fit or no? Swap has gone decently smooth so far except for the bell housing lol.
JF74chevelle- G3GM Member
- Street Cred : 0
Re: Bell housing help!!!!!
The 168 flywheel needs an 11 inch bellhousing. It will not fit in a 10.5 bellhousing. 10.5 clutch is fine as long as the flywheel has both, 11 and 10.5 inch clutch bolt patterns.
Joe73- Donating Member
- Street Cred : 83
G3GM :: G3 :: General Discussion
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|
Yesterday at 1:56 pm by REVINKEVIN / Mr. 600+HP
» Pate Swap Meet - Texas Motor Speedway - G3 Parts Goldmine
Yesterday at 12:20 pm by g3chevy / Mr Pontiac
» '73 Laguna coupe - factory 454- SoCal $2500
Fri May 17, 2024 4:38 pm by Mcarlo77
» Dash Solutions
Fri May 17, 2024 3:22 pm by 76 Malibu
» Rusty's progress Done stuff again LOL
Thu May 16, 2024 12:56 pm by Limey SE
» 1973 4 door laguna frame same as 1973 2 door chevelle
Tue May 14, 2024 4:39 pm by chevelleman
» Anyone good at photoshop?
Mon May 13, 2024 12:50 pm by 76 Malibu
» '77 Monte Carlo Landau - Parting out - 61k miles on car
Fri May 10, 2024 5:02 pm by Matchstx
» Dash assembly for 73-77 Malibu/Monte/El Camino,etc.
Fri May 10, 2024 2:48 pm by Limey SE
» Window louvers
Fri May 10, 2024 12:47 pm by JCervantes10