Posi done!
G3GM :: G3 Tech :: Engine & Driveline
Page 1 of 1
Posi done!
I just installed my Auburn carrier yesterday.Went smoothly and the car feels great!
Just FYI the rear I have dosent use C-clips its the BOP rear with bolt in axles from the factory
this was in my car from new (77 Monte) the bearings and carrier are all the same-(OTHER THAN
THE AXLE BEARINGS) as a chevy diff 8.5 ten bolt with c-clips. So if you have one of these
you just need the right axle bearings and seals and the bearings and seal need to be pressed on
the new ones also look a little different than the originals but work fine.
Just FYI the rear I have dosent use C-clips its the BOP rear with bolt in axles from the factory
this was in my car from new (77 Monte) the bearings and carrier are all the same-(OTHER THAN
THE AXLE BEARINGS) as a chevy diff 8.5 ten bolt with c-clips. So if you have one of these
you just need the right axle bearings and seals and the bearings and seal need to be pressed on
the new ones also look a little different than the originals but work fine.
ant7377- G3GM Addict
- Street Cred : 36
G3GM :: G3 Tech :: Engine & Driveline
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
|
|
Wed Mar 27, 2024 7:25 pm by 77camino
» 77 elco SS
Tue Mar 26, 2024 4:35 pm by Whisperer
» 3-g cars in Finland
Tue Mar 26, 2024 11:33 am by Finn Monte
» Stainless brake lines
Mon Mar 25, 2024 4:37 pm by Joe73
» New chassis for my 73
Sun Mar 24, 2024 9:39 pm by g3chevy / Mr Pontiac
» 1973 Chevelle SS, 350, 4spd. build
Fri Mar 22, 2024 4:21 pm by Joe73
» Rusty's progress Hood sorta Finalized and other Updates
Thu Mar 21, 2024 4:58 pm by Limey SE
» cluster metal trim
Thu Mar 21, 2024 10:23 am by Joe73
» Nos wheel well moldings
Wed Mar 20, 2024 3:33 pm by Limey SE
» Dash assembly for 73-77 Malibu/Monte/El Camino,etc.
Wed Mar 20, 2024 11:26 am by Limey SE