4 speed hump
4 posters
4 speed hump
Where do I cut the hole for the shifter for a 4speed and does any one have pictures of hump installation
McCauley5983- G3GM Enthusiast
- Street Cred : 14
Re: 4 speed hump
___________________________________________
1977 Chevelle SE x2
One Mild original
one Wild NON original
Anthony
Limey SE- Management
- Street Cred : 97
Re: 4 speed hump
Ya it wasn't that bad I cut a small hole so the shifter would fit used the center console I had lying around to center the new sheet metal the welded it in more time consuming then anything
McCauley5983- G3GM Enthusiast
- Street Cred : 14
Dead Man- G3GM Member
- Street Cred : 4
Re: 4 speed hump
Would have been a nice resource when I did mine but nobody had measurments and that post hadn't been started yet
McCauley5983- G3GM Enthusiast
- Street Cred : 14
Permissions in this forum:
You cannot reply to topics in this forum
|
|
Yesterday at 7:25 pm by 77camino
» 77 elco SS
Tue Mar 26, 2024 4:35 pm by Whisperer
» 3-g cars in Finland
Tue Mar 26, 2024 11:33 am by Finn Monte
» Stainless brake lines
Mon Mar 25, 2024 4:37 pm by Joe73
» New chassis for my 73
Sun Mar 24, 2024 9:39 pm by g3chevy / Mr Pontiac
» 1973 Chevelle SS, 350, 4spd. build
Fri Mar 22, 2024 4:21 pm by Joe73
» Rusty's progress Hood sorta Finalized and other Updates
Thu Mar 21, 2024 4:58 pm by Limey SE
» cluster metal trim
Thu Mar 21, 2024 10:23 am by Joe73
» Nos wheel well moldings
Wed Mar 20, 2024 3:33 pm by Limey SE
» Dash assembly for 73-77 Malibu/Monte/El Camino,etc.
Wed Mar 20, 2024 11:26 am by Limey SE